Flow 5 shuts when I launch an analysis

Serra HermosoSerra Hermoso asked 4 years ago

Hello, 
my problem comes when I try to launch an analysis. I define the analysis type and all the parameters required and when I click analyze, the program shuts down. I have already done various analysis in the same model and I have not any problem so I dont know what could be wrong, do you have any idea?
Thanks in advance, regards.
Pablo Serra.

André Deperroistechwinder Staff replied 4 years ago

Hello,
Looks like a very bad bug.
I’ve identified that there may be an issue in v7.12 with tri-linear analyses. Can you please confirm which type of analysis you are running, and if it’s the linear case, please switch to tri-uniform which is the recommended method anyway.
Thanks,
André

1 Answers
Serra HermosoSerra Hermoso answered 4 years ago

Hello,
I was running tri-linear analysis and when I switched to uniform analysis it worked fine. However, I realized that when I defined the tri-linear analysis, the reference area switched to 0 in the analyisis information box at the bottom-left corner, so I re-edited the analysis to establish again the area value and worked fine. This seems to happen every time I define a new analysis but the important fact is that the analysis runs. Hope that this information helps.
Thanks for answering,
Pablo.